Cart contains {{shoppingcart.totalQuantity}} Item(s) Total: {{shoppingcart.subtotal}} {{shoppingcart.total}}

Jet City 2212RC and 22H Gold Pin Option

Our Products: Full Retube™ kits for Guitar Amps > Retube™ Kits For Jet City > Jet City 2212 & 22H

Price: $232.00

Jet City 2212RC and 22H Gold Pin Option

Product Details

Want a very smooth and rich tone with less grit? This is our Gold Pin Option Retube Kit for the Jet City 2212RC Combo and 22H Amps. It uses five Gold Pin ECC83S's with one being current balanced for the phase inverter in V5. The default power tubes are a matched pair of the JJ EL84's but you can configure this kit to use the JJ EL844's to drop the power output a couple decibels by clicking on the "Customize" button!

The Balanced Gold Pin ECC83S is located in V5 which is the farthest preamp tube away from the input jack.

Combo amps are very hard on tubes because of vibrations which can cause tube rattle with any brand of tube. If your amp is the combo version and you play by yourself in a quiet environment or record with your amp you may want to consider using the EuroDamper tube damper rings for the two EL84’s. These are available in the "Related Products” tab as a set of two small dampers and will greatly decrease tube rattle. ** Note; the wire tube retainers have to be spread out to fit over the damper rings.

These amps are adjustable bias. All you need to check and set the bias is one of our 9 pin bias probes with a Multimeter, or our all-in-one 9 pin "Pro One" bias probe (which reads plate voltage and plate current simultaneously). These are available under the "Related Products" tab.

EL84's should bias up to between 22 to 26 mA per tube.
The JJ EL844's are a 9 watt tube and should bias up to between 16 to 20 mA per tube.

You can use our Generic Bias Video for reference.

The video below explains the difference between bias probe types.

Related Products...

Check the check boxes next to the additional products that you would like to add to the shopping cart, then click on the "Add to Cart" button above. A check box is not shown if a product requires that you select an option or fill out a field. (

) indicates a required accessory.

Eurotubes “Pro One” Bias Probe for EL84 power tubes

Price $139.00

Eurotubes 9-Pin Bias Probe

Price $57.00

EuroDamper Small - Pair

Price $9.00

Eurotubes 10 Gauge 3 foot Speaker Cable

Price $33.00

Eurotubes 10 Gauge 6 foot Speaker Cable

Price $42.00

© 1998 - 2014 Eurotubes Inc. All Rights Reserved
All text and images on this website may not be used without express permission.
All prices and product information subject to change without notice.