f Find us on Facebook Home Shop Online Product Info Amp Info Bias Info FAQ "+" Reviews About ET
Marshall DSL 40C and DSL 50 Gold Pin Option
Price: $202.00
Marshall DSL 40C and DSL 50 Gold Pin Option
Marshall DSL 40C and DSL 50 Gold Pin Option
Marshall DSL 40C and DSL 50 Gold Pin Option
(Click to see larger image and other views)
Product Details

This is our Gold Pin Option Retube Kit, it uses four Gold Pin ECC83S's with one being current balanced for V4. It's very smooth and lush sounding with less grit. The default power tubes are the JJ Electronic E34L’s but you can configure this kit to use the JJ EL34II's, EL34’s, KT77’s or Big Bottle 6CA7’s by clicking on the "Customize" button.

For the DSL50 the Balanced Gold Pin ECC83S is located closest to the power tubes in V4.

For the DSL40C the Balanced Gold Pin ECC83S is located farthest from the input jack in V4.

PLEASE READ THE TEXT BELOW THAT EXPLAINS THAT YOU DO NOT NEED TO USE A BIAS PROBE!!!!!


The DSL 40C and DSL 50 amps are biased between 40 to 45 Millivolts per side at the factory test points using a Multimeter.


You can use the Marshall DSL100 bias video for reference as the bias procedure is the same. Unfortunately Marshall decided to locate the trim pots on the DSL 40C inside the amp, so you must pull the chassis to bias it. The middle prong is your ground. 

The most asked question we get is "do I need bias probes that are like the ones shown in this video to bias my amp." The answer is no. If you listen to the video we will explain that we're showing two different methods of reading bias and showing the probes and meters so you can get a better visual  on how the bias works. All you need to bias one of these amps is a simple multimeter to do the job.

The second most asked question is "what setting do I use on my multimeter" The answer we give in the video is Millivolts!

The third most asked question is "do I use the black or negative lead for the middle test prong?" The answer is yes!

The fourth most asked question is "do I bias the amp in standby?" The answer is no! The amp must be in the play mode to adjust the bias.

The fifth most asked question is "do I have to have a speaker plugged in?" The answer is YES! You MUST have a speaker load on the amp.

The sixth most asked question is "what do I bias KT77's at?" The answer is EL34's, E34L's, KT77's and the big bottle JJ 6CA7's all bias up to between 40 to 45mV in the  40C and 50 watters and between 80 to 90mV in 100 watt DSL's, TSL's and JVM's


Related Products...
Check the check boxes next to the additional products that you would like to add to the shopping cart, then click on the "Add to Cart" button above. A check box is not shown if a product requires that you select an option or fill out a field. () indicates a required accessory.











© 1998 - 2014 Eurotubes Inc.  All Rights Reserved
All text and images on this website may not be used without express permission.
All prices and product information subject to change without notice.
A website for musicians by musicians. Home Shop Online Product Info Amp Info Bias Info FAQ "+" Reviews About ET Email Phone 5036597401 EUROTUBES
Preamp-Tubes-c2.htm